topic Re: Need to change FMC IP address. What is the proper process to register FTD devices back? in Network Security

Need to change FMC IP address. What is the proper process to register FTD devices back?

Jack G — Fri, 21 Feb 2020 14:14:10 GMT

I opened a ticket with support and they stated to perform the steps below, but is it the best process? Should I remove the devices first from FMC, change the FMC IP address, then register the FTD devices again? Trying to minimize and configuration issues on the FTD device with this FMC IP address change due to the FMC being relocated.

As discussed, first please take a configuration backup form the FMC.

Then, once you have moved your FMC please delete the manager from the Firepower module on the ASA:

>configure manager delete

If that gives any error, please run:

>expert

$remove_peer.pl <IP address of the FMC>

Then please add the new manager:

>configure manager add <IP address> key

Use the same key to add the Module to the FMC under Device -> Device Management.

Re: Need to change FMC IP address. What is the proper process to register FTD devices back?

Jack G — Wed, 23 Aug 2017 20:21:39 GMT

I just did some testing on one device. After changing the IP address of the FMC, the devices lost heartbeat with FMC, but after some time, the device started checking in again, so it appears that it just might take 15-20 minuters or so for the devices to reconnect with the FMC.

Re: Need to change FMC IP address. What is the proper process to regis

sreenivasR — Sun, 26 Nov 2023 04:28:50 GMT

Cisco FMC engineering prepared the script for this scenario. In future, if we need to change the FMC IP then please reach out to Cisco. We will be updating the external documentation for this procedure. If we don't find it then plz reach cisco Tac.