topic Re: FPR 2100 ASA 9.8 getting error MIO Heartbeat Failure for active and standby in Network Security

FPR 2100 ASA 9.8 getting error MIO Heartbeat Failure for active and standby

Arun More — Thu, 26 Mar 2020 07:20:51 GMT

Hi,

We have ASA 9.8 with active and standby , recently it is observed that fail over happened automatically with failure reason as MIO Heartbeat Failure for both devices (FPR2100) , when searched found that there is remedy as add command app-agent heartbeat interval 3000 retry-count 5 for Bug CSCvh26447 or to upgrade the version. Note this is not a frequent but the occasional incident. So what should be opted as solution.

current config and state

service-policy global_policy global

app-agent heartbeat interval 1000 retry-count 3

# sh failover state

State Last Failure Reason Date/Time

This host - Secondary

Active MIO Heartbeat Failure 00:00:02 UTC Feb 28 2020

Other host - Primary

Standby Ready MIO Heartbeat Failure 15:38:28 UTC Mar 24 2020

====Configuration State===

Sync Done

Sync Done - STANDBY

====Communication State===

Mac set

Regards,

Arun

Re: FPR 2100 ASA 9.8 getting error MIO Heartbeat Failure for active and standby

Cristian Matei — Thu, 26 Mar 2020 09:48:32 GMT

Hi,

I would upgrade and use lower values than the one provided as a bug workaround; in the end you want to faster detect failure to communicate over the backplane with the Firepower chasis.

Regards,

Cristian Matei.

Re: FPR 2100 ASA 9.8 getting error MIO Heartbeat Failure for active and standby

anilkumar.cisco — Thu, 26 Mar 2020 14:09:25 GMT

Hello Team,

Could you please confirm earliest, is there any impact by below command.

Command

app-agent heartbeat interval 3000 retry-count 5

Also as per you this command need to configure on system mode on globally.==> confirm on this.

Hope workaround would be good to go rather then software upgrade..

Kindly suggest..

Best Regards

Anil Singh

Re: FPR 2100 ASA 9.8 getting error MIO Heartbeat Failure for active an

Amen — Mon, 07 Nov 2022 09:25:15 GMT

Hello, I have the same problem, what have you done here? thank