topic Re: FTD 2100 - Change Management Interface IP Address in Network Security

FTD 2100 - Change Management Interface IP Address

gamoore — Fri, 21 Feb 2020 15:54:54 GMT

FTD 2110 initially setup for local FDM Management. Now, need to deploy FTD2110 with FMC Management and a new IP address. How do I change the Management IP address after the intial setup script has ran?

Re: FTD 2100 - Change Management Interface IP Address

Rahul Govindan — Tue, 26 Jun 2018 01:29:24 GMT

Since you have FDM access, I believe you should be able to change it from the FDM itself.

Via FTD CLI:

configure network ipv4 manual <mgmt0 IP> <netmask> <gateway> management0

"show network" should show you the management ip address.

Re: FTD 2100 - Change Management Interface IP Address

Salman.Baig — Sat, 26 Jan 2019 19:10:09 GMT

i configure the ip on ftd but i cant access ftd gui and also i cant ping able to the ftd 6.2.3 please help me what the problem is

Re: FTD 2100 - Change Management Interface IP Address

imanv — Sun, 20 Oct 2019 12:50:03 GMT

Thanks "Rahul Govindan",

But management0 at the end of this command is only for 4100 and 9300 series.

Don't use it on there models.

configure network ipv4 manual <mgmt0 IP> <netmask> <gateway> management0

Multiple management interfaces are supported on Firepower 4100 and 9300 series devices only. Do not specify this parameter
for other platforms. The management interface IDs on the Firepower 4100 and 9300 are management0 for the default management interface and management1 for the optional event interface.

Best Regards,

Re: FTD 2100 - Change Management Interface IP Address

vikachau — Tue, 31 Mar 2020 13:07:42 GMT

I am having the same problem -->>i configure the ip on ftd but i cant access ftd gui and also i cant ping able to the ftd 6.2.3 please help me what the problem is

Please assist,

Re: FTD 2100 - Change Management Interface IP Address

nomorenoless — Fri, 14 Feb 2025 01:43:05 GMT

repeated lol

Re: FTD 2100 - Change Management Interface IP Address

nomorenoless — Fri, 14 Feb 2025 01:42:01 GMT

is a great firewall I have been managing one of these since 2021 and it has not fail or miss the first time, great device:
to perform the task you want please run:

scope fabric-interconnect a (press enter) set out static ip <ip> net <mask> gw <gateway>

Re: FTD 2100 - Change Management Interface IP Address

nomorenoless — Fri, 14 Feb 2025 01:44:59 GMT

the command I gave you will work on FTD only if you are on ASA do what @Rahul Govindan said, but run the Firepower 2110 as ASA is a waste, run it as FTD with FMC is great solution for small-medium duties