topic Re: ASAv50 Display failover state difference CLI with ASDM in Network Security

ASAv50 Display failover state difference CLI with ASDM

jewfcb001 — Fri, 03 Apr 2020 15:49:30 GMT

We deploy ASAv50 version 9.12 but I found ASAv50 display failover state difference CLI with ASDM.

CLI Display : Active/Active

ASDM : Active/Standby

Please suggest me .

Re: ASAv50 Display failover state difference CLI with ASDM

Pulkit Saxena — Sat, 04 Apr 2020 09:51:54 GMT

Can you share the "show version" from ASA ?

-
Pulkit

Re: ASAv50 Display failover state difference CLI with ASDM

t_one_cisco — Sat, 04 Apr 2020 09:56:37 GMT

Hi Pulkit
ASAv Version 9.12(3)9

Re: ASAv50 Display failover state difference CLI with ASDM

Cristian Matei — Sat, 04 Apr 2020 10:27:04 GMT

Hi,

Can you post the following output from both ASA's? "show version", "show failover", "show failover state".

Regards,

Cristian Matei.

Re: ASAv50 Display failover state difference CLI with ASDM

Sheraz.Salim — Sat, 04 Apr 2020 20:12:49 GMT

what is the ASDM version you on.

make sure you on ASDM version 7.13.1

Re: ASAv50 Display failover state difference CLI with ASDM

jimholla — Sat, 04 Apr 2020 20:23:31 GMT

I don't think that ASAv should be running in active/active mode. What are you running the ASAv on? VMware, KVM, Azure?

Re: ASAv50 Display failover state difference CLI with ASDM

Sheraz.Salim — Sat, 04 Apr 2020 20:26:28 GMT

agree ASAv does not support active/active.

Re: ASAv50 Display failover state difference CLI with ASDM

jewfcb001 — Sun, 05 Apr 2020 04:18:56 GMT

Hi Sheraz

ASAv Version 9.12(3)9

ASDM Version : 7.12(2)14

I not install new asdm I use default asdm in default image on ASAv .

Re: ASAv50 Display failover state difference CLI with ASDM

Pulkit Saxena — Sun, 05 Apr 2020 07:04:59 GMT

I don't think this is an ASDM issue as it is showing correct output, now from CLI perspective.
If you are seeing "active/active" in "show version" output, you can ignore that, it is brought from the ASA code.
However if you are seeing "active/active" in "show failover" output, let us know and share the complete "show failover" output.
-
Pulkit

Re: ASAv50 Display failover state difference CLI with ASDM

Sheraz.Salim — Sun, 05 Apr 2020 07:34:47 GMT

@Pulkit Saxena I agree its not the ASDM issue. I was curious to know what version is on. in regards to ASA cli showing Active/Active could be a cosmetic bug. unless show failover show the same thing even though active/active (multi-context) is not supported in virtual appliance of asav.