topic Re: ssh or telnet from cisco FTD Cli in Network Security

ssh or telnet from cisco FTD Cli

bijay.swain — Fri, 21 May 2021 09:48:38 GMT

how can I use ssh/telnet to connect another device from cisco ftd cli .is this command available on FTD CLI

Re: ssh or telnet from cisco FTD Cli

Rob Ingram — Fri, 21 May 2021 09:54:52 GMT

@bijay.swain

You can login to "expert" mode and use the ssh or telnet command.

Re: ssh or telnet from cisco FTD Cli

bijay.swain — Fri, 21 May 2021 11:23:59 GMT

Hi Rob
Thanks for your reply . I tried but from expert mode ii am unable to ping the devices connected to my inside zone. all request is by default going to management port which is not connected to any network. it says no route to the host (hosts are in inside zone).

Re: ssh or telnet from cisco FTD Cli

Marvin Rhoads — Fri, 21 May 2021 15:31:34 GMT

To ssh (or telnet) from an FTD device requires using the management interface. The data plane interfaces are not available for those functions.