topic Re: Cisco FTD, interface configuration in Network Security

Cisco FTD, interface configuration

torstensson — Thu, 01 Jul 2021 10:04:35 GMT

Hi,

I did an inital setup of FTD in VMware but I can't seem to configure the IP and/or enable the interfaces in CLI. How do I enable and configure the IP through FTD CLI (I access this through VMware webconsole and not via SSH).

Re: Cisco FTD, interface configuration

Rob Ingram — Thu, 01 Jul 2021 10:16:04 GMT

@torstensson

You won't see the configuration for the data interfaces until you configure them via the FMC.

The only interface you can configure on the CLI is the management interface, use the command "show network" to confirm the configuration and "configure network....." to configure the mgmt interface settings.

Re: Cisco FTD, interface configuration

Marius Gunnerud — Thu, 01 Jul 2021 21:16:29 GMT

Only the management interface can be configured through the CLI, all other data interfaces need to be configured through GUI

Re: Cisco FTD, interface configuration

OMÇiloğlu — Fri, 02 Jul 2021 07:26:52 GMT

I wonder a little about the questions you ask in the forum, sorry. These answers are all on the net 🙂