topic Re: storage device not found in Network Security

storage device not found

seckka21 — Thu, 15 Jul 2021 21:24:58 GMT

Hello

i have an ASA 5525-x.I am reimaging it by installing firepower sfr 6.2.2.The ASA verion is 9.8.but after the command sw-module module sfr recover boot.i have this error:storage device not found.install driver and try again.

in these image we have the command show sfr module and show inventory.

Re: storage device not found

Marvin Rhoads — Fri, 16 Jul 2021 02:45:19 GMT

The ASA 5525-X requires an optional SSD to run the Firepower service module. Without that, you cannot install the module.

Re: storage device not found

seckka21 — Tue, 27 Jul 2021 15:12:18 GMT

Hi Dear

Now i have another ASA with an optional SSD .The version is 9.8 and i am reimaging firepower with version 6.2.2.3 but after the command sw-module module sfr recover boot the module is still recovery status.

Here are the version and detail about module.Please really need your help

Re: storage device not found

Marvin Rhoads — Wed, 28 Jul 2021 20:07:42 GMT

Once you've done the "recover boot" you need to session into the module and complete the setup as described in this document:

https://www.cisco.com/c/en/us/support/docs/security/asa-firepower-services/118644-configure-firepower-00.html#anc8

It will only move into operational state once the system image (vs. boot image) is installed and configured.

Re: storage device not found

seckka21 — Wed, 28 Jul 2021 20:17:42 GMT

when execute the session sfr console command i have the following output:

ciscoasa(config)# session sfr
Opening command session with module sfr.
Module sfr did not respond to session request.