https://community.cisco.com/t5/network-security/fmcv-amp-ftdv/m-p/4449266#M1082871 <P class="p">Inline Link Mismatch Alarms - This module monitors the ports associated with inline sets and alerts if the two interfaces of an inline pair negotiate different speeds.&nbsp;</P> <P class="p">Source: <A href="https://www.cisco.com/c/en/us/td/docs/security/firepower/70/configuration/guide/fpmc-config-guide-v70/health_monitoring.html" target="_blank">https://www.cisco.com/c/en/us/td/docs/security/firepower/70/configuration/guide/fpmc-config-guide-v70/health_monitoring.html</A></P> <P class="p">&nbsp;</P> <P class="p">Regards,</P> <P class="p">Chakshu</P> <P class="p"><EM>Do rate helpful posts!</EM></P> Fri, 13 Aug 2021 18:12:02 GMT Chakshu Piplani 2021-08-13T18:12:02Z https://community.cisco.com/t5/network-security/fmcv-amp-ftdv/m-p/4448881#M1082861 <P>Hi, I'm using GNS3 for a test lab. I'm trying to bring up 2x interfaces on the FTDv from FMC Gi0/0 and Gi0/1 - Gi0/0 is my inside interface, Gi0/1 my outside. I'm running the FMC in Evaluation mode and have 90 days of functiionality for testing.</P><P>&nbsp;</P><P>When I deploy I keep getting a failure 'inline link mismatch alarms (test failed as shown in the image.</P><P>&nbsp;</P><P>Anyone encountered this issue - I'm struggling to bring the 2x interfaces from admin down to up.</P><P>&nbsp;</P><P>I am running the firewall in transparent mode, not routed.</P><P>&nbsp;</P><P>Any help greatly appreciated</P> Fri, 13 Aug 2021 09:41:28 GMT https://community.cisco.com/t5/network-security/fmcv-amp-ftdv/m-p/4448881#M1082861 jaketheape 2021-08-13T09:41:28Z https://community.cisco.com/t5/network-security/fmcv-amp-ftdv/m-p/4449266#M1082871 <P class="p">Inline Link Mismatch Alarms - This module monitors the ports associated with inline sets and alerts if the two interfaces of an inline pair negotiate different speeds.&nbsp;</P> <P class="p">Source: <A href="https://www.cisco.com/c/en/us/td/docs/security/firepower/70/configuration/guide/fpmc-config-guide-v70/health_monitoring.html" target="_blank">https://www.cisco.com/c/en/us/td/docs/security/firepower/70/configuration/guide/fpmc-config-guide-v70/health_monitoring.html</A></P> <P class="p">&nbsp;</P> <P class="p">Regards,</P> <P class="p">Chakshu</P> <P class="p"><EM>Do rate helpful posts!</EM></P> Fri, 13 Aug 2021 18:12:02 GMT https://community.cisco.com/t5/network-security/fmcv-amp-ftdv/m-p/4449266#M1082871 Chakshu Piplani 2021-08-13T18:12:02Z