topic FTD SUBINTERFACE CONNECTIVITY ISSUE in Network Security

FTD SUBINTERFACE CONNECTIVITY ISSUE

isaaco001 — Tue, 16 Nov 2021 14:22:16 GMT

Dear community,

I have configured a subinterface (ip addresss, vlan) on a parent FTD interface. The connection goes to a switch trunk port. For some reason there is no connectivity between FTD and switch.

When I remove the subinterface and configure the parent interface as a normal interface then I can reach switch with not issues at all. Kindly assist to diagnose what's going on here!

I have attached the running-config of FTD and screenshots of my configs.

Thanks!

Re: FTD SUBINTERFACE CONNECTIVITY ISSUE

nspasov — Wed, 17 Nov 2021 18:24:14 GMT

I suspect your issue is with using VLAN 1 on your sub-interface. VLAN 1 is the default native VLAN on trunk ports and your configuration suggests that you are using the default configuration. You can try one of the following:

1. Change your native vlan on the switch and firepower side to something else (e.g. 999)

2. Use a different vlan for your sub-interface

I hope this helps!

Thank you for rating helpful posts!