https://community.cisco.com/t5/network-security/need-some-help-fmc-appliance-cimc-cli/m-p/4525116#M1086103 <P>If it is indeed the CIMC as you suspect, you can connect to the CIMC address via https in your browser and then open a session to the Firepower Management Center OS shell using the CIMC browser GUI.</P> Thu, 30 Dec 2021 14:40:19 GMT Marvin Rhoads 2021-12-30T14:40:19Z https://community.cisco.com/t5/network-security/need-some-help-fmc-appliance-cimc-cli/m-p/4525086#M1086102 <P><SPAN>Hello,</SPAN><BR /><SPAN>I am trying to setup a FMC 1600 appliance and have been told it's connected to it's serial port via a serial console server.</SPAN><BR /><SPAN>However, when I log into the cli, I get the following prompt: FMC cli-&gt;</SPAN><BR /><SPAN>I cannot type anything in there (I've tried ?, help, show, setup, etc. without any luck) A only get a "Error: Invalid command:" message back.</SPAN><BR /><SPAN>I suspect they connected it to the CIMC/LOM port instead and I need to know if there is anything I can do to setup this appliance from the CIMC Cli? Can I switch shell to the normal FMC CLI?</SPAN><BR /><SPAN>Thanks</SPAN></P> Thu, 30 Dec 2021 12:58:20 GMT https://community.cisco.com/t5/network-security/need-some-help-fmc-appliance-cimc-cli/m-p/4525086#M1086102 BeuranHendri 2021-12-30T12:58:20Z https://community.cisco.com/t5/network-security/need-some-help-fmc-appliance-cimc-cli/m-p/4525116#M1086103 <P>If it is indeed the CIMC as you suspect, you can connect to the CIMC address via https in your browser and then open a session to the Firepower Management Center OS shell using the CIMC browser GUI.</P> Thu, 30 Dec 2021 14:40:19 GMT https://community.cisco.com/t5/network-security/need-some-help-fmc-appliance-cimc-cli/m-p/4525116#M1086103 Marvin Rhoads 2021-12-30T14:40:19Z