topic IOS-XE Interface Configuration for FXOS CCL Container FTD 7.0 in Network Security

IOS-XE Interface Configuration for FXOS CCL Container FTD 7.0

dbotelhosybistech — Wed, 19 Jan 2022 20:27:54 GMT

How do I configure an IOS-XE switch for SpannedEt andhernet for FXOS 2.10 and FTD 7.0?

My CCL interface on the 4115 appliance remains failed and down. The 4115 has an amber light for the assigned CCL. The Portchannel 48 with a member interface eth1/7 and is logically connected to a cluster container instance. The switch is configured as an interface PO48 with a 10GB member but no luck.

Re: IOS-XE Interface Configuration for FXOS CCL Container FTD 7.0

balaji.bandi — Wed, 19 Jan 2022 20:42:17 GMT

Can you post what device and show run interface eth 1/7 and show interface ethe 1/7, show run inter port-channel 48 , show interface port 48

Re: IOS-XE Interface Configuration for FXOS CCL Container FTD 7.0

Marvin Rhoads — Thu, 20 Jan 2022 12:26:01 GMT

Make sure the MTU size on the interfaces is adjusted to account for the cluster overhead. i.e., at least 100 bytes higher than the data interfaces.

https://www.cisco.com/c/en/us/td/docs/security/firepower/640/configuration/guide/fpmc-config-guide-v64/clustering_for_the_firepower_threat_defense.html#concept_AB605DC2227F4CB1BAED60C9ADB67787