topic When does Cisco FDM support interfaces to be inline or inline with tap in Network Security

When does Cisco FDM support interfaces to be inline or inline with tap

nicholas183183 — Mon, 14 Feb 2022 02:03:41 GMT

Hi All,

When does Cisco FDM support configure interfaces to be inline or inline set with inline tap?

Nicholas

Re: When does Cisco FDM support interfaces to be inline or inline with

Amine ZAKARIA — Mon, 14 Feb 2022 04:15:54 GMT

Hello,

I have checked the last version of FDM still not supported, When? i don't think anytime soon.

Limitations for Interface Configuration
When you use Firepower Device Manager to configure the device, there are several limitations to interface configuration. If you need any of the following features, you must use Firepower Management Center to configure the device.
You cannot configure interfaces to be inline (in an inline set), or inline tap

For more info:
https://www.cisco.com/c/en/us/td/docs/security/firepower/710/fdm/fptd-fdm-config-guide-710/fptd-fdm-interfaces.html#concept_6940083A55184D009B6406EF167C9DD4

Regards!
----------------------------------------
Don't forget to rate helpful posts.

Re: When does Cisco FDM support interfaces to be inline or inline with

nicholas183183 — Tue, 15 Feb 2022 08:49:01 GMT

Hi Amine ZAAmine,

Thanks your information.

I have got the limitation on FDM, so I want to know is there have any plan or schedule to support inline set on FDM?

Nicholas

Re: When does Cisco FDM support interfaces to be inline or inline with

Marvin Rhoads — Tue, 15 Feb 2022 13:22:06 GMT

I would be surprised to see it in FDM anytime soon as Cisco targets only the most commonly used features for FDM and recommends FMC for customers with more uncommon or advanced use cases.