topic Re: FP1100 Firepower network port is not getting active in Network Security

FP1100 Firepower network port is not getting active

rajeesh.mariyodan — Fri, 04 Mar 2022 10:54:30 GMT

This is standalone firewall not connected to internet:

I am started in Cisco devices , i have configured the ciscso firewall and connected the network cable .

But not able to enable the port , port was enable from the web gui.

Please find the attached photos , how to get the port 5 acive

Rob Ingram — Fri, 04 Mar 2022 10:58:52 GMT

@rajeesh.mariyodan I assume you've deployed the policy to the FTD?

rajeesh.mariyodan — Fri, 04 Mar 2022 11:34:49 GMT

Yes policy was already deployed , is there anything else i need to do to enable the network port .

As port 5 when network cable , LED also not even flashing.

Rob Ingram — Fri, 04 Mar 2022 11:46:05 GMT

@rajeesh.mariyodan ok, just checking.

That's all you need to do to enable the interface, have you tried enabling another port? Same issue?

Have you replaced the cable?

Have you tried using a different interface on the switch?

rajeesh.mariyodan — Fri, 04 Mar 2022 16:03:04 GMT

When the device was switch on it was configurated with enabled with inside and outside port.

I have connected same switch and cable to port 2 then its showing green color .

Attached some more configuration .

rajeesh.mariyodan — Fri, 04 Mar 2022 16:21:29 GMT

i did some more try , i have pressed discard - due to this all my setting lost and become base seeting when firewall was powered on

As i am getting deployment error every time

rajeesh.mariyodan — Sat, 05 Mar 2022 12:14:48 GMT

Looks like changed done is not able to deployed to the firewall , may be issue related to below bug .