topic Re: FMC showing wrong model in Network Security

FMC showing wrong model

muath1987 — Tue, 29 Mar 2022 00:19:49 GMT

Hello

I finsised a mogartion of FMC appliance (4000 to 4600), the primary appliance is up and everything looks good on it but the secondary FMC showing model 4000 while it should be 4600, there is a command can be run from shell which can modify the model, please if anyone knows this command post it here.

Re: FMC showing wrong model

Udupi Krishna. — Tue, 29 Mar 2022 01:45:26 GMT

The CLI procedure is/was meant for legacy Sourcefire hardware. Can you run "show model" from the cli of both FMC(s) and verify the output returned?

Re: FMC showing wrong model

Jitendra Kumar — Tue, 29 Mar 2022 05:55:09 GMT

Yes @Marvin Rhoads ,

I can see your old comments that resolved the issue.

@muath1987 you can check below use case if its help you

https://community.cisco.com/t5/network-security/can-fmc-running-in-vsphere-be-migrated-to-aws/td-p/4569305

Thanks,

Jitendra