topic Re: Problem FW asa 5512 for HA in Network Security

Problem FW asa 5512 for HA

Dhikra Marghli — Fri, 22 Apr 2022 08:21:52 GMT

Hello

we have two device ASA CISCO 5512 with HA ( primary and secondary ).

so i have problem :

FW1-Primary ( Active )

FW2-secondary ( Failed )

and it is we have an error message

one device is unknown state

you will find two pictures about error mesage :

Please , i need from expert security reply me and help me about this problem

Thanks

Re: Problem FW asa 5512 for HA

Rob Ingram — Fri, 22 Apr 2022 08:26:41 GMT

@Dhikra Marghli has this ever worked?

Can you please run "show failover" and "show failover history" and provide the output.

Re: Problem FW asa 5512 for HA

balaji.bandi — Fri, 22 Apr 2022 08:51:02 GMT

if this is working one Failed or new setup :

FW2-secondary ( Failed )

Either case, check is the device online, by console, check the cables between devics. try to reload secondary and check.

Re: Problem FW asa 5512 for HA

Dhikra Marghli — Mon, 25 Apr 2022 07:37:35 GMT

Hello

you will find an attachment that contains outpout for two commands : show failover" and "show failover history"

thanks to chek and i wait a reply for this problem

Thanks

Re: Problem FW asa 5512 for HA

Dhikra Marghli — Mon, 25 Apr 2022 07:38:15 GMT

Thanks to check

Re: Problem FW asa 5512 for HA

Rob Ingram — Mon, 25 Apr 2022 07:42:16 GMT

@Dhikra Marghli check the INSIDE interface on the secondary ASA.

This host: Secondary - Failed
Active time: 0 (sec)
slot 0: ASA5512 hw/sw rev (3.0/9.9(2)88) status (Up Sys)
Interface diagnostic (0.0.0.0): Normal (Waiting)
Interface INSIDE (0.0.0.0): No Link (Waiting)

Check and replace the cable, check the interface configuration on the switch is correct. Attempt to ping the interface IP address.