Change the FMC Access Interface from Management to Data

rezaalikhani — Mon, 20 Jun 2022 04:09:51 GMT

Hi all;

According to Cisco's technical documentation, one of the steps to change the FMC access interface from management to data is executing the following command:

configure network {ipv4 | ipv6} manual ip_address netmask data-interfaces

My question is that, which IP address should I use for the "ip_address" field? The current IP address for management interface, the IP address of the interface that I enabled for FMC Access or something else?

Thanks

Re: Change the FMC Access Interface from Management to Data

Mohammed al Baqari — Mon, 20 Jun 2022 08:47:19 GMT

Hi,

The command you posted will change the IP address of the FMC management
interface and make the data interface as the gateway instead of
separate gateway. So you can use the same management interface IP.

***** please remember to rate useful posts

topic Re: Change the FMC Access Interface from Management to Data in Network Security

Change the FMC Access Interface from Management to Data

Re: Change the FMC Access Interface from Management to Data