topic Re: ASA Interface issue in Network Security

ASA Interface issue

virendra pathak — Sat, 16 Jul 2022 01:53:41 GMT

Dear Team,

As per attached topology attached, i would like to map ASA port eth 0 and eth 1 in INSIDE interface ?

How shall i achieve this design ? Is it possible ?

regards

Virendra p

Re: ASA Interface issue

MHM Cisco World — Sat, 16 Jul 2022 03:17:47 GMT

https://www.petenetlive.com/KB/Article/0001422

Use bvi as example above

Re: ASA Interface issue

balaji.bandi — Sat, 16 Jul 2022 07:37:03 GMT

Are you looking to separate the network, what is the goal here as Firewall -

if " i would like to map ASA port eth 0 and eth 1 in INSIDE interface ? "

If you looking DC firewall to be transparent mode - may be worth looking below example (this is my just guess what you trying to achieve)

https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/110740-asafailover-transparent-mode.html

Re: ASA Interface issue

Aref Alsouqi — Sat, 16 Jul 2022 16:27:09 GMT

Why would you want to do that? I think the only option to do it would be to create a bridge interface and place eth0 and eth1 in that bridge group, but that means both interfaces will need to be on the same subnet.