Porting config - FMC to FortiVM

Fred SM — Tue, 18 Apr 2023 13:20:49 GMT

Hi,
From what I've gathered there's approximately no way of exporting the config of the FMC other than the ACLs which I got using the below option:
http://archive.dependencyhell.net/2017-07-09-dumping-firepower-acp/

So since there's no easy way of getting the config out of a FMC / Firepower, am I right in assuming that there's no better way to do this than painfully porting the config one rule, object, NAT etc. at a time?

I am pretty sure I know the answer which is "yes. ready, set, go fix!", but I would love to get some confirmation before going through too much of this path of painful exhaustion.

Thanks in advance.

Kind regards,
Fred

Re: Porting config - FMC to FortiVM

Fred SM — Tue, 25 Apr 2023 09:40:54 GMT

Turns out I found a solution to pulling out the config.
On the Firepower itself it's possible to run a "show startup-config" which outputs the majority of the config.

topic Re: Porting config - FMC to FortiVM in Network Security

Porting config - FMC to FortiVM

Re: Porting config - FMC to FortiVM