Firepower 1120 FDM Problem with GUI + SSH

Derek1993 — Mon, 26 Jun 2023 17:57:02 GMT

Hello
I have very interesting problem. After some changes I cann't login into my FDM FP 1120 on 192.168.1.1. The FP configured as Router and enabled DHCP for clients - for all clients FP 1120 as Gateway 192.168.1.1. For now I can login only via Console Port Micro-USB and screen.

Here is the output of show network:

===============[ System Information ]=============== Hostname : Firewall Domains : www.cisco.com DNS Servers : 208.67.222.222 208.67.220.220 DNS from router : disabled Management port : 8305 IPv4 Default route Gateway : data-interfaces ==================[ management0 ]=================== State : Enabled Link : Up Channels : Management & Events Mode : Non-Autonegotiation MDI/MDIX : Auto/MDIX MTU : 1500 MAC Address : 40:06:D5:85:FF:80 ----------------------[ IPv4 ]---------------------- Configuration : DHCP ----------------------[ IPv6 ]---------------------- Configuration : Disabled ===============[ Proxy Information ]================ State : Disabled Authentication : Disabled

Re: Firepower 1120 FDM Problem with GUI + SSH

Marius Gunnerud — Tue, 27 Jun 2023 07:43:44 GMT

You are using DHCP for you management IP? Have you tried configuring a static IP instead?

Re: Firepower 1120 FDM Problem with GUI + SSH

MHM Cisco World — Tue, 27 Jun 2023 09:32:46 GMT

the mgmt interface is connect to SW which SW then reconnect to INside of FPR?

topic Re: Firepower 1120 FDM Problem with GUI + SSH in Network Security

Firepower 1120 FDM Problem with GUI + SSH

Re: Firepower 1120 FDM Problem with GUI + SSH

Re: Firepower 1120 FDM Problem with GUI + SSH