https://community.cisco.com/t5/network-security/multiple-port-channels-using-same-vlans-fp1010/m-p/4922783#M1104234 <P>Currently I have a Firepower 1010 managed by FMC.</P><P>I want to have 2 x VLANS, a management VLAN (100) and then a LAN VLAN (with DHCP) (200).</P><P>From then I want to have 2 port channels (EtherChannels) with 2 Ethernet Ports each which will then go to 2 x switches configured with a Port Channel.</P><P>I can't seem to figure out how I can create 2 x Port Channels with both VLAN 100 and 200 trunked through them via FMC.&nbsp; I have tried with subinterfaces but it will only let me use a VLAN once and only if it doesn't exist.</P><P>On an ASA switch I would just create the port channel using the basic commands then add the interfaces to the port channels but I can't seem to figure this out in FMC.</P><P>&nbsp;</P> Wed, 13 Sep 2023 14:12:26 GMT nickh1234 2023-09-13T14:12:26Z https://community.cisco.com/t5/network-security/multiple-port-channels-using-same-vlans-fp1010/m-p/4922783#M1104234 <P>Currently I have a Firepower 1010 managed by FMC.</P><P>I want to have 2 x VLANS, a management VLAN (100) and then a LAN VLAN (with DHCP) (200).</P><P>From then I want to have 2 port channels (EtherChannels) with 2 Ethernet Ports each which will then go to 2 x switches configured with a Port Channel.</P><P>I can't seem to figure out how I can create 2 x Port Channels with both VLAN 100 and 200 trunked through them via FMC.&nbsp; I have tried with subinterfaces but it will only let me use a VLAN once and only if it doesn't exist.</P><P>On an ASA switch I would just create the port channel using the basic commands then add the interfaces to the port channels but I can't seem to figure this out in FMC.</P><P>&nbsp;</P> Wed, 13 Sep 2023 14:12:26 GMT https://community.cisco.com/t5/network-security/multiple-port-channels-using-same-vlans-fp1010/m-p/4922783#M1104234 nickh1234 2023-09-13T14:12:26Z