topic Re: ACP rule not showing any zones or objects while creating a new rul in Network Security

ACP rule not showing any zones or objects while creating a new rule

PacketSpartan — Wed, 15 May 2024 17:24:37 GMT

We used the migration tool to migrate our ASA config to FTD, Auto assigned the zones and Interface groups.

When we try an create a new ACP rule, we're not seeing the zones or any of the objects that was migrated over. We can see the all the objects in the object management section, we can also see the zones in the interface section.

The FTDs are currently on 7.3.1, we plan to upgrade them to 7.4 before we go live.

Anyone come across this issue?

Re: ACP rule not showing any zones or objects while creating a new rul

MHM Cisco World — Wed, 15 May 2024 17:49:57 GMT

You see zone with interface' are the interface is enable or disable?

MHM

Re: ACP rule not showing any zones or objects while creating a new rul

PacketSpartan — Wed, 15 May 2024 21:40:16 GMT

Its all enabled, under the device' port settings. Although there is nothing connected to it