topic FTD diagnostic-cli - Can enable or disable an interface? in Network Security https://community.cisco.com/t5/network-security/ftd-diagnostic-cli-can-enable-or-disable-an-interface/m-p/5167772#M1115492 <P>Can I configure the FTD interface using the LINA (<EM>diagnostic</EM><SPAN>-</SPAN><EM>cli<SPAN>&nbsp;) in exec mode or Enable and Disable the interface ?</SPAN></EM></P><P><EM><SPAN>I'm trying to move my outside interface from eth1/1 to eth1/13(10GB)&nbsp;</SPAN></EM></P><P>&nbsp;</P> Thu, 29 Aug 2024 16:23:44 GMT Almanak2012 2024-08-29T16:23:44Z FTD diagnostic-cli - Can enable or disable an interface? https://community.cisco.com/t5/network-security/ftd-diagnostic-cli-can-enable-or-disable-an-interface/m-p/5167772#M1115492 <P>Can I configure the FTD interface using the LINA (<EM>diagnostic</EM><SPAN>-</SPAN><EM>cli<SPAN>&nbsp;) in exec mode or Enable and Disable the interface ?</SPAN></EM></P><P><EM><SPAN>I'm trying to move my outside interface from eth1/1 to eth1/13(10GB)&nbsp;</SPAN></EM></P><P>&nbsp;</P> Thu, 29 Aug 2024 16:23:44 GMT https://community.cisco.com/t5/network-security/ftd-diagnostic-cli-can-enable-or-disable-an-interface/m-p/5167772#M1115492 Almanak2012 2024-08-29T16:23:44Z Re: FTD diagnostic-cli - Can enable or disable an interface? https://community.cisco.com/t5/network-security/ftd-diagnostic-cli-can-enable-or-disable-an-interface/m-p/5167774#M1115493 <P><a href="https://community.cisco.com/t5/user/viewprofilepage/user-id/1774729">@Almanak2012</a> no, the only supported method to disable data interfaces is via the GUI.</P> Thu, 29 Aug 2024 16:31:24 GMT https://community.cisco.com/t5/network-security/ftd-diagnostic-cli-can-enable-or-disable-an-interface/m-p/5167774#M1115493 Rob Ingram 2024-08-29T16:31:24Z