topic Re: Using FlexConfig to change default command (no sysopt noproxyarp) in Network Security

Using FlexConfig to change default command (no sysopt noproxyarp) rule

KMNRuser — Tue, 15 Oct 2024 17:35:04 GMT

Community,

We are trying to change a default behavior on an FPR 1010 platform. the interface in question has the command "no sysopt noproxyarp" configured on it. We are trying to understand how we can use a Flexconfig in FMC to change this behavior so that it does not proxy arp back to the host in question.. How can we change the behavior to turn off the proxyarp feature on the interface?

Sincerely,

KMNRuser

Re: Using FlexConfig to change default command (no sysopt noproxyarp)

KMNRuser — Tue, 15 Oct 2024 20:18:23 GMT

I have found this within the FMC Interface.. I am just not sure how to adjust it to turn off the Proxy Arp feature..

Re: Using FlexConfig to change default command (no sysopt noproxyarp)

Aref Alsouqi — Tue, 15 Oct 2024 18:19:06 GMT

Please take a look at this link:

FTD FlexConfig (lookingpoint.com)