topic Re: Reset management interface IP address through CLI on Firepower 101 in Network Security

Reset management interface IP address through CLI on Firepower 1010

EvanC75 — Fri, 30 Jun 2023 05:18:53 GMT

Can someone tell me what the command is through CLI to reset the management IP address on a Firepower 1010? The Cisco documentation for this is wrong. It does not provide any examples and no matter what I try, it says syntax error.

This is what I am trying and it does not work.

connect ftd
configure network management-data-interface ipv4 manual 10.0.1.1 255.255.255.0

Re: Reset management interface IP address through CLI on Firepower 101

Rob Ingram — Fri, 30 Jun 2023 06:50:01 GMT

@EvanC75 use configure network ipv4 manual <ip address> <netmask> <gateway>

You can confirm that worked using the command show network

Re: Reset management interface IP address through CLI on Firepower 101

EvanC75 — Fri, 30 Jun 2023 07:22:06 GMT

Thank you. I had a hard time finding the show network command.

What confused me from the Cisco documentation is it told me to do it like this which apparently is wrong:

configure network management-data-interface ipv4 manual 10.0.1.1 255.255.255.0 default-gw 10.0.1.254
Also I tried it without the default gateway.

So basically I didn't need the "management-data-interface" part of it.

Re: Reset management interface IP address through CLI on Firepower 101

jroy777 — Fri, 18 Apr 2025 01:37:50 GMT

How do I change the management interface on a 3130 to be on the "inside" interface but before that, how do I set nameif to inside on a different interface (want to use 10G instead of 1G)?