3130's Howto: configure network management-interface and shut / no sht

jroy777 — Mon, 28 Apr 2025 17:29:24 GMT

Hello,

Have two 3130's. Set up individually and then set them to do HA. Come to find out we are going to use SFMC. SFMC requires the HA can only be enabled AFTER the devices are connected to it. I broke HA and expected the original IP I used for the secondary setup and management to be available but the config is wiped. So now I am trying to setup the 2nd unit and I cannot set an IP on it from the cli? Can we even do a shut/no shut from the cli???

I applied configure network management-interface enable Management1/1 and it keeps saying not a valid interface.
How do I get this to work? I want to connect the secondary to SFMC and setup HA.

Re: 3130's Howto: configure network management-interface and shut / no

nspasov — Wed, 30 Apr 2025 17:02:47 GMT

The CLI syntax to change the management interface IP is configure network followed by the desired attributes. For instance:

configure network ipv4 manual 192.168.10.49 255.255.0.0 192.168.255.254

Thank you for rating helpful posts!

topic Re: 3130's Howto: configure network management-interface and shut / no in Network Security

3130's Howto: configure network management-interface and shut / no sht

Re: 3130's Howto: configure network management-interface and shut / no