ASDM image

D@1984 — Fri, 21 Feb 2020 16:19:33 GMT

Hi,

I'm tryng to load asdm image on asa using tftp but it fails.

I simply configured a port on asa with an ip and put my pc on the same subset. I can ssh to ASA from my PC but cant connect to tftp on my PC. I set wireshark but cant capture any tftp traffic.

ping to asa from my pc is successful but from asa to pc it fails.

Is there something missing from config?

:
ASA Version 8.4(3)
!
hostname ciscoasa
enable password 8Ry2YjIyt7RRXU24 encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
!
interface Ethernet0/0
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet0/1
shutdown
no nameif

asa version: Version 8.4(3)

Thanks

no security-level
no ip address
!
interface Ethernet0/2
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet0/3
nameif m
security-level 90
ip address 10.10.10.1 255.255.255.0
!
interface Management0/0
nameif Management
security-level 100
ip address 192.168.1.1 255.255.255.0
!
ftp mode passive
pager lines 24
mtu Management 1500
mtu m 1500
no failover
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
timeout xlate 3:00:00
timeout pat-xlate 0:00:30
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
user-identity default-domain LOCAL
aaa authentication ssh console LOCAL
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart warmstart
telnet timeout 5
ssh 10.10.10.0 255.255.255.0 m
ssh timeout 5
console timeout 0
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
username cisco password 3USUcOPFUiMCO4Jk encrypted
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns migrated_dns_map_1
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns migrated_dns_map_1
inspect ftp
inspect h323 h225
inspect h323 ras
inspect ip-options
inspect netbios
inspect rsh
inspect rtsp
inspect skinny
inspect esmtp
inspect sqlnet
inspect sunrpc
inspect tftp
inspect sip
inspect xdmcp
!
service-policy global_policy global
prompt hostname context
no call-home reporting anonymous
call-home
profile CiscoTAC-1
no active
destination address http https://tools.cisco.com/its/service/oddce/services/DDCEService
destination address email callhome@cisco.com
destination transport-method http
subscribe-to-alert-group diagnostic
subscribe-to-alert-group environment
subscribe-to-alert-group inventory periodic monthly
subscribe-to-alert-group configuration periodic monthly
subscribe-to-alert-group telemetry periodic daily
Cryptochecksum:e1b76d2784e638373fda48f9e4f9ec0c

**I set IP address on my pc to 10.10.10.10 and set the default gateway:10.10.10.1**

Re: ASDM image

Alex Pfeil — Fri, 05 Oct 2018 02:12:23 GMT

Did you check firewall on your PC?

Re: ASDM image

Dennis Mink — Fri, 05 Oct 2018 06:01:24 GMT

Run wireshark on your PC then see if the PC has incoming TFTP. if it does, then yes most likely local FW blocking it

Re: ASDM image

Marius Gunnerud — Sat, 06 Oct 2018 08:50:16 GMT

Turn off the windows firewall on your PC or at least allow tftp in the firewall as this has a tendency to drop this traffic.

Re: ASDM image

mkazam001 — Sat, 03 Nov 2018 23:55:07 GMT

always easier to do via the network & ssh to the asa (can use free solarwinds tftp server) or if it's a 5515-X or higher, you can use the USB port.

hope that helps

azam

topic ASDM image in Network Security

ASDM image

Re: ASDM image

Re: ASDM image

Re: ASDM image

Re: ASDM image