topic ASA firepower initial setup in Network Security

ASA firepower initial setup

sobin peter — Tue, 12 Mar 2019 09:47:15 GMT

Hi I am stuck up in configuring the firepower in the ASA 5508.

Provided a different subnet IP to the firepower management and connected to the switch port but i couldn't able to access the firepower interface. But i am able to access the asdm to ASA.

Can someone suggest the the way to configure the initial setup.

Regards.

Please share output of the

Marvin Rhoads — Tue, 08 Aug 2017 05:22:56 GMT

Please share output of the following from ASA cli:


show ip
show module sfr detail

...and confirm that you have physically connected the ASA management interface (used by the sfr module) to a switchport in the VLAN where the assigned management subnet is active.

Hello Sobin

Jetsy Mathew — Wed, 09 Aug 2017 10:39:54 GMT

Hello Sobin

Hope the following link which help you in finishing the setup based on the connectivity scenario you have in your environment.

https://www.cisco.com/c/en/us/support/docs/security/ips-sensor-software-version-71/113690-ips-config-mod-00.html

https://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/sfr/firepower-qsg.html

Regards

Jetsy