https://community.cisco.com/t5/network-security/activate-bgp-in-cisco-ftd/m-p/3086841#M134050 <P>Thank you</P> Wed, 19 Jul 2017 01:14:43 GMT Firstwavetechnology 2017-07-19T01:14:43Z https://community.cisco.com/t5/network-security/activate-bgp-in-cisco-ftd/m-p/3086839#M134048 <P>Hi,</P> <P></P> <P>I can show BGP in Cisco FTD from command line interface with this command: "show bgp"</P> <P>How can I&nbsp;activate BGP and set its ASN from command line interface?</P> <P></P> <P>Also, when BGP is not active, I get the following correct response:</P> <P class="p1"><SPAN class="s1">&gt; show bgp</SPAN></P> <P class="p1"><SPAN class="s1">% BGP not active</SPAN></P> <P class="p1">However, after I activate&nbsp;BGP from the web GUI, why do I not get any information (i.e. empty response)?</P> <P><SPAN>&gt; show bgp</SPAN></P> <P><SPAN></SPAN></P> <P>Thanks.</P> Tue, 12 Mar 2019 09:42:20 GMT https://community.cisco.com/t5/network-security/activate-bgp-in-cisco-ftd/m-p/3086839#M134048 Firstwavetechnology 2019-03-12T09:42:20Z https://community.cisco.com/t5/network-security/activate-bgp-in-cisco-ftd/m-p/3086840#M134049 <P>You cannot configure FTD from CLI, you will need to use FMC (or FDM for small ASAs) UI to configure bgp.&nbsp;</P> <P></P> <P>"show bgp" displays your bgp routing table so in case you dont have any neighbors up you will see nothing.</P> Tue, 18 Jul 2017 16:56:08 GMT https://community.cisco.com/t5/network-security/activate-bgp-in-cisco-ftd/m-p/3086840#M134049 Oliver Kaiser 2017-07-18T16:56:08Z https://community.cisco.com/t5/network-security/activate-bgp-in-cisco-ftd/m-p/3086841#M134050 <P>Thank you</P> Wed, 19 Jul 2017 01:14:43 GMT https://community.cisco.com/t5/network-security/activate-bgp-in-cisco-ftd/m-p/3086841#M134050 Firstwavetechnology 2017-07-19T01:14:43Z