Failover Failed status

foued kh — Tue, 12 Mar 2019 09:00:56 GMT

Hi Team,

We have 2 ASA5515-x in failover Active/Standby mode.
Recently, a failover has accured. I had this status :

Failover On 
Failover unit Secondary
Failover LAN Interface: FOLINK GigabitEthernet0/2 (up)
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 5 seconds, holdtime 25 seconds
Interface Policy 1
Monitored Interfaces 3 of 114 maximum
MAC Address Move Notification Interval not set
Version: Ours 9.2(2)4, Mate 9.2(2)4
Last Failover at: 13:38:20 CEST Feb 6 2017
 This host: Secondary - Active 
 Active time: 2270284 (sec)
 slot 0: ASA5515 hw/sw rev (1.0/9.2(2)4) status (Up Sys)
 Interface INTERNET (x.x.x.x): Normal (Waiting)
 Interface LAN (x.x.x.x): Normal (Monitored)
 Interface WAN (x.x.x.x): Normal (Waiting)
 slot 1: SFR5515 hw/sw rev (N/A/5.3.1.6-16) status (Up/Up)
 ASA FirePOWER, 5.3.1.6-16, Up
 Other host: Primary - Failed 
 Active time: 0 (sec)
 slot 0: ASA5515 hw/sw rev (1.0/9.2(2)4) status (Up Sys)
 Interface INTERNET (0.0.0.0): Normal (Waiting)
 Interface LAN (x.x.x.x): Normal (Monitored)
 Interface WAN (x.x.x.x): No Link (Waiting)
 slot 1: SFR5515 hw/sw rev (N/A/5.3.1.6-16) status (Up/Up)
 ASA FirePOWER, 5.3.1.6-16, Up

What do you suggest for me, please to change the state of the second firewall from "Failed" status to "Standby" status.

Regards

On the secondary firewall the

Marvin Rhoads — Sun, 05 Mar 2017 02:03:35 GMT

On the secondary firewall the WAN interface is down.

This condition is indicated in the following line:

Interface WAN (x.x.x.x😞 No Link (Waiting)

Fix the root cause for that and the unit should revert to "Standby" status.

I am sorry for the daly Mr.

foued kh — Sat, 11 Mar 2017 20:54:17 GMT

I am sorry for the delay Mr. Marvin.
Thank you so much for your advice.

You're welcome.

Marvin Rhoads — Sun, 12 Mar 2017 01:40:43 GMT

You're welcome.

Please mark your question as answered if it has been.

topic Failover Failed status in Network Security

Failover Failed status

What do you suggest for me, please to change the state of the second firewall from "Failed" status to "Standby" status.

On the secondary firewall the

I am sorry for the daly Mr.

You're welcome.