topic You can use this guide to in Network Security

Initial Configuration of 5506-x

JosephPhilip1 — Tue, 12 Mar 2019 08:56:11 GMT

I am very new to Firewalls. My Company recently bought some 5506-X with FTD Licences. I am not familiar with configuring this device. If I take the console access to this device its not similar to the conventional ASA insted it ask us to set some management IP and all these things. So do anyone have any guides or ideas on how to configure this one?

You can use this guide to

Rahul Govindan — Wed, 15 Feb 2017 02:10:26 GMT

You can use this guide to start configuration of the ASA5506 with FTD.

http://www.cisco.com/c/en/us/td/docs/security/firepower/quick_start/5506X/ftd-fmc-5506x-qsg.html

Is there any way I can

JosephPhilip1 — Fri, 17 Feb 2017 19:37:43 GMT

Is there any way I can configure this device without connecting to internet or any switch. I usually configure the ASA's and then put it in production. I want to know whether we can do the same with this device ??

You can definitely configure

Mohammed al Baqari — Sat, 18 Feb 2017 08:00:03 GMT

You can definitely configure it through console,

http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/sfr/firepower-qsg.html

Initial configuration for

Marius Gunnerud — Sat, 18 Feb 2017 13:22:46 GMT

Initial configuration for management interface IP and which subnets are allowed to manage the device can be done through CLI. For the actual access policy configuration you would need access to the GUI. I have never tried connecting a PC directly to the management interface so you might need a cross-over cable for that if you do not have a dumb switch you could use for a staging area.

Please remember to select a correct answer and rate helpful posts