https://community.cisco.com/t5/network-security/management-interface-active-standby-with-different-ip-scope/m-p/2997739#M148417 <P>Management interface ip addresses must be on the same subnet. Interface configuration is synced from the active to the standby unit.</P> <P></P> <P>Mark as helpful if this answers your question</P> Wed, 16 Nov 2016 17:35:55 GMT Oliver Kaiser 2016-11-16T17:35:55Z https://community.cisco.com/t5/network-security/management-interface-active-standby-with-different-ip-scope/m-p/2997738#M148396 <P>In a&nbsp;ASA Active/Standby setup, could I use differnet IP Scopes for the Management Interface or do the Management IP's have to be in same IP range?</P> Tue, 12 Mar 2019 08:32:37 GMT https://community.cisco.com/t5/network-security/management-interface-active-standby-with-different-ip-scope/m-p/2997738#M148396 Markus Truetsch 2019-03-12T08:32:37Z https://community.cisco.com/t5/network-security/management-interface-active-standby-with-different-ip-scope/m-p/2997739#M148417 <P>Management interface ip addresses must be on the same subnet. Interface configuration is synced from the active to the standby unit.</P> <P></P> <P>Mark as helpful if this answers your question</P> Wed, 16 Nov 2016 17:35:55 GMT https://community.cisco.com/t5/network-security/management-interface-active-standby-with-different-ip-scope/m-p/2997739#M148417 Oliver Kaiser 2016-11-16T17:35:55Z https://community.cisco.com/t5/network-security/management-interface-active-standby-with-different-ip-scope/m-p/2997740#M148433 <P>Thanks very much</P> Thu, 17 Nov 2016 06:43:06 GMT https://community.cisco.com/t5/network-security/management-interface-active-standby-with-different-ip-scope/m-p/2997740#M148433 Markus Truetsch 2016-11-17T06:43:06Z