topic ASA 5510 Failover Licensing in Network Security

ASA 5510 Failover Licensing

pcarlet — Tue, 12 Mar 2019 08:23:48 GMT

I purchased a pair of refurbished ASA 5510 (Sec Plus) to create a ACTIVE/STANDBY failover.

When I check 'show activation-key', it shows:

Failover : Active/Active

How do I change this to active/standby? I thought Sec Plus license was for either failover configuration. I tried adding the line 'failover lan unit secondary' to see if that would update it, but it does not.

Do I have the wrong license? Is there something I need to do to change this? I definitely do not want to try active/active config.

thanks in advance!!

The output you see from the

Marvin Rhoads — Thu, 13 Oct 2016 15:29:35 GMT

The output you see from the show command is normal. "Active/Standby" is considered as a subset of "Active/Active".

If you did not have the necessary license, the ASA would not accept the "failover lan unit secondary" command.

Once you have setup both units, you can check the status with "show failover"

thanks for the clarification

pcarlet — Thu, 13 Oct 2016 15:32:04 GMT

thanks for the clarification Marvin! second unit has not arrived...but just wanted make sure I didnt order the wrong licensed versions. cheers