Scansafe/CWS General Options Command Missing

GRANT3779 — Tue, 12 Mar 2019 08:14:37 GMT

I run active/active failover and trying to configure Scansafe/CWS within my routed context.

I am following the document here and have set this up many times in the past, although never when running ASA in multiple contexts.

https://supportforums.cisco.com/document/125616/asa-scansafe-step-step-configuration

5516-01/routed(config)# scansafe general-options
^
ERROR: % Invalid input detected at '^' marker.

The show commands for Scansafe are there, just not actual config commands. If I switch to system context all the commands are available. Do I need to configure this within the system context?

Thanks

Problem sorted. General

GRANT3779 — Thu, 08 Sep 2016 19:27:22 GMT

Problem sorted. General Options to be done in system context and also a scansafe command under the context within system config. You can use license overwrite also for specific context.

topic Scansafe/CWS General Options Command Missing in Network Security

Scansafe/CWS General Options Command Missing

Problem sorted. General