topic Hi there, in Network Security

Initial configuration of ASA Firepower?

cisco — Tue, 12 Mar 2019 07:50:31 GMT

Hi,

I have set up a new ASA 5525-X with Firepower-services and now I want to configure the Firepower-services from the Firepower-mangement. The basic functionality of the ASA with accesslists, routing, NAT, VPN etc is up and running, but as said, I want to set up the malware and intrusion policies in the Firepower-management. Is there any good documentation and/or checklists to follow on this? What I want first is to set up the Firepower-services to monitor the traffic and give reposrts for a couple of weeks before changing the config to actually block unwanted traffic.

Best regards,

Thor-Egil

Hi Thor,

ankojha — Fri, 03 Jun 2016 09:34:05 GMT

Hi Thor,

You can follow the configuration guide for setting up policies, reporting and logging :

http://www.cisco.com/c/en/us/support/security/asa-firepower-services/products-installation-and-configuration-guides-list.html (select as per the version of the management center )

Rate if it helps.

Thanks,

Ankita

Hi there,

Kasun Bandara — Sun, 05 Jun 2016 16:57:29 GMT

Hi there,

you can find good guide set in this thread.

https://supportforums.cisco.com/discussion/13019421/initial-installtion-firepower-and-cisco-asa

regards,

Kasun

Hello Team,

Jetsy Mathew — Mon, 06 Jun 2016 05:31:51 GMT

Hello Team,

Here is the quick refrence for the installation guides and deployment scenarios. Please refer thode before starting the deployment in your architecture.

Deployment Scenarios:-

http://www.cisco.com/c/en/us/support/docs/security/ips-sensor-software-version-71/113690-ips-config-mod-00.html

Quick start guide:-

http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/sfr/firepower-qsg.html

Installation Guide :-

http://www.cisco.com/c/en/us/support/docs/security/asa-firepower-services/118644-configure-firepower-00.html

Rate if this post helps you

Regards

Jetsy