https://community.cisco.com/t5/network-security/command-configurations/m-p/4008475#M15533 <P>Apologies but I'm new to cisco and command configurations and to be honest I'm at my wits end.</P><P>&nbsp;</P><P>I have been set an assignment to configure the following to an existing network.</P><P>My education establishment uses version 7.2.1 although I'm not sure if this is relevant to my question.</P><P>&nbsp;</P><P>I have to configure a GRE tunnel between two networks,</P><P>Add an OSPF, Add a VPN tunnel,</P><P>Add a Firewall between a router and Firewall switch, and create a zone-based firewall between the two.</P><P>The instructions to complete this are questionable and I have literally spent days trying to configure the commands without success.</P><P>My progress is monitored on the simulator and I have managed to achieve 78% but can't get any higher and to be honest, I have lost confidence in the instructions.</P><P>&nbsp;</P><P>Would anyone be kind enough to give me the commands for the above so I have a fresh start, please?</P><P>I don't need the basic config stuff that's already done just the security additions.</P><P>&nbsp;</P><P>Thanks from a very stressed student. SB.</P> Fri, 21 Feb 2020 17:49:20 GMT sbarrm10015676 2020-02-21T17:49:20Z https://community.cisco.com/t5/network-security/command-configurations/m-p/4008475#M15533 <P>Apologies but I'm new to cisco and command configurations and to be honest I'm at my wits end.</P><P>&nbsp;</P><P>I have been set an assignment to configure the following to an existing network.</P><P>My education establishment uses version 7.2.1 although I'm not sure if this is relevant to my question.</P><P>&nbsp;</P><P>I have to configure a GRE tunnel between two networks,</P><P>Add an OSPF, Add a VPN tunnel,</P><P>Add a Firewall between a router and Firewall switch, and create a zone-based firewall between the two.</P><P>The instructions to complete this are questionable and I have literally spent days trying to configure the commands without success.</P><P>My progress is monitored on the simulator and I have managed to achieve 78% but can't get any higher and to be honest, I have lost confidence in the instructions.</P><P>&nbsp;</P><P>Would anyone be kind enough to give me the commands for the above so I have a fresh start, please?</P><P>I don't need the basic config stuff that's already done just the security additions.</P><P>&nbsp;</P><P>Thanks from a very stressed student. SB.</P> Fri, 21 Feb 2020 17:49:20 GMT https://community.cisco.com/t5/network-security/command-configurations/m-p/4008475#M15533 sbarrm10015676 2020-02-21T17:49:20Z