topic Bring back failover on Primary/Active ASA in Network Security

Bring back failover on Primary/Active ASA

johnlloyd_13 — Tue, 12 Mar 2019 07:45:35 GMT

hi all,

i've configured 2x ASA for active/standby and i think i've messed up the config.

was trying to 'force' the standby ASA with the 'no failover active' command on the active ASA.

i'm seeing the 'NoFailover' hostname prompt and 'Failover Off' when i issue the 'show failover' command.

can someone advise how to enable/activate again the failover feature on active ASA on the 'admin' context?

FW01/pri/actNoFailover# sh failover
Failover Off
Last Failover at: 01:12:06 UTC May 17 2016
This context: Disabled
Active time: 0 (sec)

Would you mind posting your

Elizabeth Owen — Tue, 17 May 2016 15:35:39 GMT

Would you mind posting your failover configs?

Was your active/standby working before? Is your failover enabled?

Hi

Henrik Grankvist — Tue, 17 May 2016 20:11:17 GMT

It looks you like you have disabled failover by using the command "no failover", so to enable it just write the command "failover" again.

hi,

johnlloyd_13 — Wed, 18 May 2016 02:46:11 GMT

hi,

looks like i've mistakenly issued a 'no failover' instead of 'no failover active' when i was doing a failover test.

all good now 🙂

FW01/pri/act# show failover
Failover On
Last Failover at: 04:15:26 UTC May 17 2016
        This context: Active
                Active time: 51985 (sec)
                  Interface outside (103.29.5.6): Normal (Monitored)
                  Interface inside (172.27.24.4): Normal (Monitored)
        Peer context: Standby Ready
                Active time: 0 (sec)
                  Interface outside (103.29.5.7): Normal (Monitored)
                  Interface inside (172.27.24.5): Normal (Monitored)