load balancing with ASA?

louis0001 — Tue, 12 Mar 2019 06:59:03 GMT

Hi,

not sure this is the right forum but here goes.....

We have 40 sites on an MPLS network that are connected to 2 central sites. The 2 central sites are directly connected via a 100mb ethernet connection and are about 100 miles apart.

One of those sites is the ingress/egress point to our network and we use 2x 5520 in failover mode.

What we want to do is create another ingress/egress at the second site and load balance our internet connection. Can this be achieved and if so, briefly how and withe what ASA?

Thank you....

Hi Louis,

Shivapramod M — Fri, 04 Dec 2015 11:22:54 GMT

Hi Louis,

The PBR which is useful to create loadblancing of ISP is only availble after 9.4.1. But this version is not availble for the 5520 device. It is availble for X series of the firewall.

You can refer the below link which explains some of the ways to do the load blancing.

https://supportforums.cisco.com/document/49756/asapix-load-balancing-between-two-isp-options

Thanks,
Shivapramod M
Please remember to select a correct answer and rate helpful posts

topic Hi Louis, in Network Security

load balancing with ASA?

Hi Louis,