topic Hi in Network Security

FirePower Management Center 6.0 - Not seeing any output from Firepower Sensor

Martin Houde — Fri, 21 Feb 2020 13:47:53 GMT

Hello folks,

I just deployed an inline firepower sensor and added it to the FMC 6.0. I have created a simple access policy with Intrusion Prevention.

It's been in service for the past 3 hours and I don't see anything in the management console.

The policy-map is well configured and the access-list is seeing hit counts.

Anyone have a beginners guide to creating an access-control policy on the Firepower Management Center, specifically 6.0? I have 5.4 working with another customer...

Thanks in advance! 🙂

Martin

Hi

yogdhanu — Sat, 23 Apr 2016 05:41:09 GMT

You can probably check if logging is enabled on that rule.

Policies are more or less same on both 5.4 and 6.0 . If the traffic matches default rule , make sure logging is enabled there.

Indeed, access-policies are

Martin Houde — Mon, 25 Apr 2016 18:41:39 GMT

Indeed, access-policies are the same...

However, applying a policy is not as straight forward. And that was the problem, the policy was not applied!

http://www.cisco.com/c/en/us/td/docs/security/firepower/60/configuration/guide/fpmc-config-guide-v60/Policy_Management.html