topic Thank you for the quick in Network Security

Migrating from ASA 8.4 to 9.5

Wajma_2 — Tue, 12 Mar 2019 06:39:12 GMT

Hello,

I am replacing existing ASA 5520 8.4 firewall with ASA 5545X 9.5, I am migrating the configuration from the existing firewall to the new one. What I have done so far, I have extracted the 8.4 configuration and applied it on the 9.5 section by section. The configuration seems matching when I check on the ADSM. I still have to connect it and test but before doing so, is there any issue that I should be watching for any specific difference the I should be aware of. Just to mention I had configured the new firewall when it was version 9.4 and then I upgraded to 9.5.

Thanks in advance

Hi,I don't think these should

Vibhor Amrodia — Fri, 25 Sep 2015 17:49:15 GMT

Hi,

I don't think these should be any major change between the ASA 8.4 and 9.x code other than the unitfied ACL for IPv4 and IPv6.

Rest most of the Firewall (ACL , NAT etc) should be the same in these code versions.

Thanks and Regards,

Vibhor Amrodia

Thank you for the quick

Wajma_2 — Fri, 25 Sep 2015 18:37:15 GMT

Thank you for the quick response.

Best Regards

hi,what do you mean by

Abhradeep.Banerjee — Wed, 14 Oct 2015 07:45:17 GMT

hi,

what do you mean by "unitfied ACL for IPv4 and IPv6." ? I am not using IPV6 addresses.

Hi Abhradeep, Support for

Rishabh Seth — Wed, 14 Oct 2015 07:52:48 GMT

Hi Abhradeep,

Support for unified ACL for IPv4 and IPv6 means that you can haves ACLs with mic of IPv4 and IPv6 addresses for source and destination addresses.

For more details you can refer: http://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/asa_90_cli_config/acl_extended.html#pgfId-1046350

Hope it helps!!!

Thanks,

R.Seth

Mark the answer as correct if it helps in resolving your query!!!