topic It appears that the "log" in Network Security

Real time monitor only shows OUTSIDE interface traffic

digidwain2 — Tue, 12 Mar 2019 05:59:00 GMT

I am having some issues - one of them being that our ASA5525x stopped showing all traffic on all interfaces recently. I can only see the traffic going through the "outside" interface. When I use an IP for a filter and it is not using the outside interface, I see no traffic - even though I know it is working. Is there something that I should look at in order to ascertain the issue? I checked the running/startup config but I really do not see anything that would indicate an issue.

Hi,How about using the "show

Vibhor Amrodia — Sat, 23 May 2015 12:51:47 GMT

Hi,

How about using the "show interface" and "show traffic" commands to verify the traffic going thru the ASA device ?

Thanks and Regards,

Vibhor Amrodia

It appears that the "log"

digidwain2 — Tue, 26 May 2015 18:33:22 GMT

It appears that the "log" statement was removed from the access. I placed it back on the internal side, now I can see my monitoring. Strange - I am unsure why this was removed - perhaps when I was working with TAC to resolve PRSM issues. Not sure. It appears to work now though.