topic Configure bandwidth priority in cisco ASA in Network Security

Configure bandwidth priority in cisco ASA

engineer_msu — Tue, 12 Mar 2019 05:50:40 GMT

Dear All,

I am not too good with Cisco ASA, but I can follow the instructions if given.

I need to configure QoS to reserve bandwidth for one of the public IP. This IP is for Video Conferencing.

Please any one let me know which steps shall I follow to accomplish this task.

Hi,I think the basic

Vibhor Amrodia — Mon, 27 Apr 2015 11:15:49 GMT

Hi,

I think the basic configuration syntax you would be able to find in this document:-

http://www.cisco.com/c/en/us/support/docs/security/pix-500-series-security-appliances/91790-pixasa7x-traffic-mgt.html

You can match only the traffic going to/from this Public in the access list and reference it in the class map.

Thanks and Regards,

Vibhor Amrodia

Dear Vibhor,The Cisco

engineer_msu — Mon, 27 Apr 2015 12:32:05 GMT

Dear Vibhor,

The Cisco telepresence device is configured for the public IP x.x.x.x, is the below configuration correct. Please check once then I will apply.

access-list VIDEO-CONFERENCE extended permit ip host <PUBLIC_IP> any

class-map VIDEO-CONFERENCE
match access-list VIDEO-CONFERENCE

policy-map global_policy
class VIDEO-CONFERENCE
priority (I get below error when I give priority)
ERROR: Class VIDEO-CONFERENCE has 'priority' set without 'priority-queue' in any interface

Note: Is it possible to assign the bandwith for this IP. I want to assign 2 Mbps bandwidth. The 2 Mbps bandwidth should be reserved for this IP when the internet link is full.

Please let me know, how to verify as well. Thank You very much.