topic Are you ever able to have the in Network Security

IPsec Tunnel unstable

engineer_msu — Tue, 12 Mar 2019 05:39:36 GMT

Dear Experts,

I am facing an issue with IPsec Tunnel. the tunnel is unstable.

We have Cisco ASA at HO and Cisco Router at Remote Branch.

from HO we have 5 tunnels, all are stable, only one tunnel is unstable. it is establishing and then disconnecting. Please let me know what shall I check at remote end as every thing seems to be fine with ASA.

the MM_WAIT message keep on changing and the status becoming MM_ACTIVE, then after 1 minute the tunnel is going down. Then again the same cycle is repeated.

Please help to understand the issue.

Are you ever able to have the

jj27 — Thu, 19 Mar 2015 14:10:55 GMT

Are you ever able to have the tunnel up for a long amount of time and are you able to pass any traffic at all across the tunnel? If not, to me that suggests that phase 1 is completing, but your phase 2 is mismatched. If you do show crypto ipsec sa peer x.x.x.x where x.x.x.x is the peer IP address, do you see any SAs listed when the tunnel is in MM_ACTIVE state?

The tunnel was up and it was

engineer_msu — Thu, 19 Mar 2015 17:58:09 GMT

The tunnel was up and it was working perfectly. The problem started just two days back. We didnt made any change either in firewall or router. This problem started autometically. Even now when the tunnel is showing as active, we are able to ping the remote lan but its becoming active just for 1 min then going down again.