topic Hello Jouni, I have the in Network Security

Allow PPTP pass through

opnineopnine — Tue, 12 Mar 2019 05:23:54 GMT

Hi all,

I have a Pix 515e version 6.1(5) I need to let PPTP pass through, is there any special configuration I have to do?

I have already enabled the pptp on the ACLs.

Thanks.

Hi, If you have a device in

Jouni Forss — Tue, 27 Jan 2015 08:20:29 GMT

Hi,

If you have a device in the LAN to which you connect then I think you will need to configure Static NAT for that device to give it a public IP address. There is also a "inspect pptp" configuration.

The software on your firewall is so old that I am not sure what the configuration format is though. I think in the older softwares the above "inspect" command was actually "fixup pptp"

I would suggest looking at replacing your current firewall. The current software level is very very old.

- Jouni

Hello Jouni, I have the

opnineopnine — Tue, 27 Jan 2015 13:18:01 GMT

Hello Jouni,

I have the static route configured , the only thing missing will be "fixup protocol pptp 1723"

If i add this lines can I have any impact to the devices, I ask this because is an old version.

Thanks.

Hi all, Know i have the error

opnineopnine — Wed, 28 Jan 2015 19:06:36 GMT

Hi all,

Know i have the error 806, after applying the "fixup protocol pptp 1723"

Thanks.