topic thank you very much. in Network Security

ASDM Packet Capture

dcanady55 — Tue, 12 Mar 2019 05:01:58 GMT

Hello,

I am new to the ASA world so if there is a better way to do the following I would appreciate any suggestions. I need to capture what type of traffic is leaving our network on a daily basis, this should include source and destination ports. I will be capturing traffic for a weeks time in order to better our rules. I have gone into tools and preferences and under the packet capture wizard I put in Wireshark. In setting up the capture, I did the following for the ingress interface I selected the inside interface and I choose to specify packet parameters. For the source host/Network and destination host/network I am leaving them both at all zeros to capture everything. Same goes for the egress interface settings and I choose the outside interface. I am leaving the protocol defaulted to IP. From there I'm changing the buffer to be the max size and then starting the capture. Once it's running for a little bit I save that capture and clear the buffer and then repeat this process. This doesn't seem to be very efficient and I'm hoping there's a better way? ASDM version 6.6(1) and ASA Version 8.6(1)2 device type is ASA5525

Thanks,

Hi,I think much easier way of

Vibhor Amrodia — Thu, 06 Nov 2014 08:38:17 GMT

Hi,

I think much easier way of doing this would be to use some monitoring tools like Netflow , SNMP etc.

There are some freeware also available for these tools.If you want you can also check for Threat detection statistics grah on the ASDM.

https://supportforums.cisco.com/document/30471/netflow-asa

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/113685-asa-threat-detection.html

EDIT:- Also , applying captures with IP ANY ANY might have some performance impact.

Thanks and Regards,

Vibhor Amrodia

thank you very much.

dcanady55 — Wed, 12 Nov 2014 16:53:05 GMT

thank you very much.