Newbie ASA - basic interface configuration/ping question

news2010a — Tue, 12 Mar 2019 04:51:49 GMT

Hi, imagine both interfaces below are up.

I am configuring an ASA for the first time.

What am I missing to ping from my own MYASA to the interfaces below?

!
interface GigabitEthernet0/0
nameif internal
security-level 100
ip address 1.1.1.1 255.255.255.0
MYASA# sh run int g0/2
!
interface GigabitEthernet0/2
nameif dmztest
security-level 0
ip address 2.2.2.2 255.255.255.0
MYASA# ping 1.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
No route to host 1.1.1.1

Success rate is 0 percent (0/1)
MYASA# ping 2.2.2.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2.2.2.2, timeout is 2 seconds:
No route to host 2.2.2.2

Success rate is 0 percent (0/1)
MYASA#

Couple things to check 1. Are

david-swope — Fri, 03 Oct 2014 21:39:44 GMT

Couple things to check

1. Are interfaces up?

2. Are you inspecting ICMP?

topic Couple things to check 1. Are in Network Security

Newbie ASA - basic interface configuration/ping question

Couple things to check 1. Are