Packet Tracer - Subinterface Security Zone Membership

tresdodi — Sun, 05 Jan 2020 17:11:16 GMT

Hello everybody. Is subinterface security zone membership supported in Packet Tracer? The command to assign a subinterface to a zone is not recognized:

Router(config)#zone security HOME
Router(config-sec-zone)#exit
Router(config)#int f0/0.1
Router(config-subif)#zone-member security HOME
                     ^
% Invalid input detected at '^' marker.

However, assigning a physical interface to a zone works fine:

Router(config)#int f0/0
Router(config-if)#zone-member security HOME
Router(config-if)#

I'm using Packet Tracer 7.3.0.0838 with the 2811 router. My real 1941ISR accepts putting a subinterface on a zone fine. (1941ISR does not support ZBFW in Packet Tracer).

topic Packet Tracer - Subinterface Security Zone Membership in Network Security

Packet Tracer - Subinterface Security Zone Membership