https://community.cisco.com/t5/network-security/aip-ssm-reset-without-triggering-failover/m-p/2543287#M237196 <P>Yes I have done this.</P><P>When there is no active policy redirecting traffic to the IPS module, its operational status will not affect failover state of an HA pair.</P><P>Be sure it is operational before re-enabling the policy.</P> Wed, 25 Jun 2014 14:29:13 GMT Marvin Rhoads 2014-06-25T14:29:13Z https://community.cisco.com/t5/network-security/aip-ssm-reset-without-triggering-failover/m-p/2543286#M237195 <P>Hi all, we have two asa 5510 in Active/Standby fail over mode with AIP-SSM modules. We have urgent requirement to reset AIP-SSM module. Is it possible to do this without triggering fail over on asa. Somewhere its mentioned that its possible by removing ips policy on ASA. Has anyone done that without resulting into fail over.</P> Tue, 12 Mar 2019 04:22:57 GMT https://community.cisco.com/t5/network-security/aip-ssm-reset-without-triggering-failover/m-p/2543286#M237195 GurjitSra 2019-03-12T04:22:57Z https://community.cisco.com/t5/network-security/aip-ssm-reset-without-triggering-failover/m-p/2543287#M237196 <P>Yes I have done this.</P><P>When there is no active policy redirecting traffic to the IPS module, its operational status will not affect failover state of an HA pair.</P><P>Be sure it is operational before re-enabling the policy.</P> Wed, 25 Jun 2014 14:29:13 GMT https://community.cisco.com/t5/network-security/aip-ssm-reset-without-triggering-failover/m-p/2543287#M237196 Marvin Rhoads 2014-06-25T14:29:13Z