topic ah we actually have a copy of in Network Security

Cisco Pix 515E PDM or Web Gui

parisvcisco — Tue, 12 Mar 2019 04:17:18 GMT

I don't have much experience with firewalls so I'm trying to find out how I can manage a Pix 515e via a Gui or a web front end, whilst I try and get my head around the cli.

I've seen posts about a PIX pdm but I cannot find where to download it. I'd also need some details on how to install/enable it.

some details from sh ver:

Cisco PIX Security Appliance Software Version 8.0(4)

Compiled on Thu 07-Aug-08 19:42 by builders
System image file is "flash:/image.bin"
Config file at boot was "startup-config"

pix01 up 286 days 0 hours
failover cluster up 1 year 223 days

Hardware: PIX-515E, 128 MB RAM, CPU Pentium II 433 MHz
Flash E28F128J3 @ 0xfff00000, 16MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB

The PIX was end of life / end

Marius Gunnerud — Wed, 04 Jun 2014 11:26:44 GMT

The PIX was end of life / end of support last year, So there is no support from Cisco on this product any more.

However you can download the PDM here, but you are required to have a valid Cisco support contract to be able to download it.

Please remember to select a correct answer and rate helpful posts

ah we actually have a copy of

parisvcisco — Wed, 04 Jun 2014 11:45:11 GMT

ah we actually have a copy of this in our software share along with pix804.bin.

what is the procedure to install this?

You can find installation

Marius Gunnerud — Wed, 04 Jun 2014 11:47:58 GMT

You can find installation instruction at the following URL:

http://www.cisco.com/en/US/docs/security/pix/pix63/pdm30/installation/guide/pdm30CH3.html#wp1002608

Please remember to select a correct answer and rate helpful posts

great thanks for your help.

parisvcisco — Wed, 04 Jun 2014 12:23:41 GMT

great thanks for your help.

Any time, Thank you for the

Marius Gunnerud — Wed, 04 Jun 2014 12:26:18 GMT

Any time, Thank you for the rating

1 issue is that these

parisvcisco — Wed, 04 Jun 2014 13:08:29 GMT

1 issue is that these instructions seem to be for a new device as it says run setup, which I don't want to do.

once I do this:

copy tftp://Your_TFTP_Server_IP_Address/Your_pdmfile_name flash:pdm

what would be the next step?

Try the following (where the

Marius Gunnerud — Wed, 04 Jun 2014 13:21:24 GMT

Try the following (where the management IP/subnet is the IP or subnet that is allowed to manage the firewall and "inside" is the interface name management traffic is entering the firewall):

http server enable

http <management IP/subet> inside

aaa authentication http console LOCAL

username cisco password cisco

Please select a correct answer and rate helpful posts