https://community.cisco.com/t5/network-security/error-cluster-pool-must-be-specified-on-this-interface/m-p/3949495#M23971 <P>does your deployment is in active standby mode or its in cluster.&nbsp; I guess your deployment was in cluster mode and now its converted into active standby mode.</P><P>&nbsp;</P><P>from global config mode, enter the command:</P><P>no cluster interface-mode</P><P>&nbsp;</P><P>after this you should be able to configure the ip address</P> Mon, 28 Oct 2019 21:21:47 GMT Sheraz.Salim 2019-10-28T21:21:47Z https://community.cisco.com/t5/network-security/error-cluster-pool-must-be-specified-on-this-interface/m-p/3949026#M23970 <DIV class="tlid-input input"><DIV class="source-wrap"><DIV class="input-full-height-wrapper tlid-input-full-height-wrapper"><DIV class="source-input"><DIV class="source-footer-wrap source-or-target-footer"><DIV class="character-count tlid-character-count"><DIV class="cc-ctr normal"><SPAN>Hi everybody!</SPAN></DIV></DIV></DIV></DIV></DIV></DIV></DIV><DIV class="tlid-results-container results-container"><DIV class="tlid-result result-dict-wrapper"><DIV class="result tlid-copy-target"><DIV class="text-wrap tlid-copy-target"><DIV class="result-shield-container tlid-copy-target"><SPAN class="tlid-translation translation"><SPAN>I have a problem: I configured two ASA 5512-X devices in Active / Standby mode.</SPAN> <SPAN class="">However, when I configured the management interface 0/0, I assigned the IP to the interface and said "ERROR: Cluster pool must be specified on this interface."</SPAN> <SPAN>.</SPAN> <SPAN>My ass helped me overcome the error.</SPAN><BR /><SPAN>Thank you very much.</SPAN></SPAN></DIV></DIV></DIV></DIV></DIV> Mon, 28 Oct 2019 08:17:26 GMT https://community.cisco.com/t5/network-security/error-cluster-pool-must-be-specified-on-this-interface/m-p/3949026#M23970 huyenvv 2019-10-28T08:17:26Z https://community.cisco.com/t5/network-security/error-cluster-pool-must-be-specified-on-this-interface/m-p/3949495#M23971 <P>does your deployment is in active standby mode or its in cluster.&nbsp; I guess your deployment was in cluster mode and now its converted into active standby mode.</P><P>&nbsp;</P><P>from global config mode, enter the command:</P><P>no cluster interface-mode</P><P>&nbsp;</P><P>after this you should be able to configure the ip address</P> Mon, 28 Oct 2019 21:21:47 GMT https://community.cisco.com/t5/network-security/error-cluster-pool-must-be-specified-on-this-interface/m-p/3949495#M23971 Sheraz.Salim 2019-10-28T21:21:47Z