ASA Failover | failover group ?

Jon Eyes — Tue, 12 Mar 2019 03:15:55 GMT

We just purchased two asa firewall to be setup in an active/active configuration. But when im doing my initial configuration, the failover group command is somewhat missing

ASA1(config)# failover ?

configure mode commands/options:

interface Configure the IP address to be used for failover and/or

stateful update information

interface-policy Set the policy for failover due to interface failures

ipsec Configure the use of IPSec tunnel for failover

key Configure the failover shared secret or key

lan Specify the unit as primary or secondary or configure the

interface and vlan to be used for failover communication

link Configure the interface and vlan to be used as a link for

stateful update information

mac Specify the virtual mac address for a physical interface

polltime Configure failover poll interval

replication Enable HTTP (port 80) connection replication

timeout Specify the failover reconnect timeout value for

asymmetrically routed sessions

<cr>

exec mode commands/options:

active Make this system to be the active unit of the failover pair

exec Execute command on the designated unit

reload-standby Force standby unit to reboot

reset Force a unit or failover group to an unfailed state

Looking at the license, i got this

Licensed features for this platform:

Maximum Physical Interfaces : Unlimited perpetual

Maximum VLANs : 150 perpetual

Inside Hosts : Unlimited perpetual

Failover : Active/Active perpetual

Encryption-DES : Enabled perpetual

Encryption-3DES-AES : Enabled perpetual

Security Contexts : 2 perpetual

GTP/GPRS : Disabled perpetual

AnyConnect Premium Peers : 2 perpetual

AnyConnect Essentials : Disabled perpetual

Other VPN Peers : 750 perpetual

Total VPN Peers : 750 perpetual

Shared License : Disabled perpetual

AnyConnect for Mobile : Disabled perpetual

AnyConnect for Cisco VPN Phone : Disabled perpetual

Advanced Endpoint Assessment : Disabled perpetual

UC Phone Proxy Sessions : 2 perpetual

Total UC Proxy Sessions : 2 perpetual

Botnet Traffic Filter : Disabled perpetual

Intercompany Media Engine : Disabled perpetual

Cluster : Disabled perpetual

ASA1(config)# failover group 1

ERROR: % Invalid input detected at '^' marker.

Active/Active failover is enable

Anybidy have an idea what am i missing?

Thanks

ASA Failover | failover group ?

Collin Clark — Wed, 11 Dec 2013 15:46:48 GMT

Have you already configured failover? Are you in the system context?

ASA Failover | failover group ?

Jon Eyes — Thu, 12 Dec 2013 00:35:33 GMT

Thanks Collin.

Already figured it out. I was still in single mode

I'll continue the configuration and if I come across any issue, i'll post it here.

Wish me luck

topic ASA Failover | failover group ? in Network Security

ASA Failover | failover group ?

ASA Failover | failover group ?

ASA Failover | failover group ?